QMS CrownCopy Instrukcja Konfiguracji Pobierz pdf (Strona 33)

$

+$. 

7 Attach the SCSI interface card to the controller board.

a Position the SCSI interface card so that its ribbon cable

connector aligns with the SCSI connector on the controller

board.

b Gently press the ribbon cable connector down until it’s fully

seated.





 Caution:

Make sure that the connectors on the ribbon cable

and the controller board are properly aligned. Damage to the

controller board could result if the pins are misaligned.

c Insert the SCSI interface card connector into its opening in

the interface panel.

5 Remove the two screws holding the

metal plate over the SCSI interface

opening.

The SCSI interface opening is labelled “SCSI.”

It’s located next to the “Serial” and “Key” ports.

You can discard the metal plate and screws.

6 Attach the ribbon cable to its connector

on the SCSI interface card.

..................

...................

..................

...................

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 125 126

Brak uwag

QMS CrownCopy Instrukcja Konfiguracji Strona 33