QMS 2425 Dokumentacja Strona 23

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 228
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 22
6LQJOH,Q/LQH
0HPRU\
0RGXOHV
0HPRU\D QG6\VWHP6RIWZD UH
5 Tilt the SIMM up to a 90° angle until you feel it snap into
place behind the clips on either side of the connector.
When seated, the SIMM stands upright, firmly in place. If you
cannot snap the SIMM into place, do not force it. Reposition it,
making sure that the bottom of the SIMM is seated completely in
the connector.
6 Repeat steps 3-5 for each additional SIMM being installed.
7 Reinstall the controller board in the printer.
Use the instructions in the Reinstalling Controller Board” section,
earlier in this chapter.
...................................
...................................
...................................
...................................
..................
..................
.......................................
.......................................
Przeglądanie stron 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 227 228

Komentarze do niniejszej Instrukcji

Brak uwag